View source for PartKeepr on Raspberry Pi

PartKeepr can run on a Raspberry Pi.

== Raspberry Pi ==

PartKeepr 0.76 was tested on a Raspberry Pi Model B running on Apache and mod_php 5.6. It's very slow and it's not recommended to run PartKeepr 0.76 on such slow hardware.

== Raspberry Pi 2 ==

PartKeepr 0.76 was tested on a Raspberry Pi 2 running on Apache and mod_php 5.6. It's not very fast, but usable.

Initial login to PartKeepr may take a while. As soon as data is cached, logins should become faster.

In order to achieve best performance, you should ensure that:
* Ensure your [http://php.net/manual/en/info.configuration.php max_execution_time] is set to 120 seconds or higher, this is required for the setup.
* [http://php.net/manual/en/opcache.configuration.php#ini.opcache.enable Opcache] enabled
* PHP-APCu installed and enabled with both [https://github.com/partkeepr/PartKeepr/blob/master/app/config/parameters.php.dist#L122 cache.dunglas] and [https://github.com/partkeepr/PartKeepr/blob/master/app/config/parameters.php.dist#L132 cache.doctrine]
* Ensure you don't have [http://xdebug.org/ xdebug] installed - it slows down PHP and is only used for debugging.
* Using a fast SD card (Class 10 or better)

Loading a page with 50 parts takes about 3-4 seconds. Without opcache and APC, load times for a page with 50 parts takes about 9 seconds.